Operation Panel Removal - Epson 680Pro - LQ B/W Dot-matrix Printer Service Manual

EPSON Stylus COLOR 680/777/777i
When removing the Upper Housing from the left and right Panel,
don't broke these parts since they were fastened slightly with glue.
(Refer to following pictures.)
n Tightening Torque for screw
• C.B.S-TITE R3x6 F/Uc screw for housing front side: 6 +/- 1kgf.cm
• C.B.S 3x6 F/Zn screw for housing back side
n It is not necessary to glue the Upper Housing to the Left and
Right Panel.
n Ensure that C.B.S-TITE 3 x 6 F/Uc screws are used for the two
screws on the front side of the printer. The tips of these screws
are rounded for user's safty.
Disassembly and Assembly
F a s t e n P o r t i o n
: 6+/- 1kgf.cm

4.2.2 Operation Panel removal

The panel board equipped with printer is as follows:
- Stylus COLOR 680: C383PNL
1. Remove the Housing from the printer. (Refer to Section 4.2.1.)
2. Remove 2 screws (C.B.S 3x6 F/Zn) securing the Operation Panel Assembly. Then,
disconnect the Operation Panel Assembly from the Printer Mechanism.
Figure 4-4. Removing 2 screws for Operation Panel
Disassembly
Revision B
C.B.S 3x6 F/Zn
67