Drain Pump - Asko D5110 Operating Instructions Manual

Cleaning

Drain pump

The pump can be accessed from inside the
machine.
1. Cut the power to the machine by unplug-
ging it or turning off the circuit breaker.
2. Remove the coarse filter and pipe
section.
3. Remove the small sump plug at the left of
the bottom drain (see the image below).
4. You can release and turn the pump blade
by inserting your finger into the hole and
release anything blocking it.
5. Reinstall the fitted piece and filters.
6. Plug the machine in or turn the circuit
breaker back on.
18
If the machine still does not start and a
buzzing sound is heard, the overflow guard
has been activated.
• Shut off the water.
• Unplugg the machine or turn off the circuit
breaker.
• Call the service division.
Note:
Do not forget to reinstall the sump plug.
The spray arms
The spray arm holes and bearings can
sometimes become blocked.
1. Pull the lower washer arm straight up to
release it.
2. Remove any deposits using a needle or
similar.
The washer arms also have holes under
neath.
Customer Care Center
1-800-898-1879
www.askousa.com