Asko D5110 Operating Instructions Manual page 11

Basic Course
Press start
The dishwasher will now start. It man-
ages the entire wash automatically. Ensure
that the door is properly closed or the ma-
chine will not start.
Changing program
If you wish to change the program after
having started the machine, press the Start/
Stop button for three seconds. Then select a
new program and press the Start/Stop but-
ton again.
Do you want to load more dishes?
Carefully open the door; the machine will
stops automatically, put in the dishes, close
the door and the dishwasher will continue
from where it left off.
If the machine is switched off at the
main switch
(or in the event of a loss of power cut) before
the washing program has been completed,
the interrupted program will continue when
the power comes back on.
Note:
If the power is switched off, or if the door
is open during drying, the program is inter-
rupted.
7
Standby mode
Once the program is complete, the machine
will only draw a very small amount of power.
If you want you can turn the power off at the
main power switch. Turn off the water supply
to the machine if it is not to be used for an
extended period, e.g. during holidays.
The indicators around the Start/Stop but-
ton field gradually light up as the program
progresses.
When the program finishes, all the indica-
tors around the Start/Stop button will be
lit. These lights will remain on for up to two
hours or until you open the door. The lights
for the programs and options will always be
lit as long as the main power switch for the
machine is turn on.
Customer Care Center
1-800-898-1879
www.askousa.com
11