To replace a memory module:
1.
Remove the computer cover. Refer to "Removing the computer cover".
Note: For this procedure, it helps to lay the computer on its side.
2.
Locate the memory module connectors. Refer to "Locating components".
3.
Remove the memory module being replaced by opening the retaining clips as
shown.
4.
Position the new memory module over the memory connector. Make sure
the notch
system board. Push the memory module straight down into the connector
until the retaining clips close.
5. Refer to the "Completing the installation".
31035102_3000 H_HRG_EN.indd 13
on the memory aligns correctly with the connector key
on the
Hardware Replacement Guide
2008.8.21 2:19:24 PM
13