HP dc7900 - Convertible Minitower PC Service & Reference Manual page 104

NOTE:
the extra power connectors.
6. Connect the power cable (1) and data cable (2) to the rear of the optical drive or diskette drive.
Figure 7-32
7. If you are installing a new drive, connect the opposite end of the data cable to the appropriate
system board connector.
NOTE:
connector on the system board labeled SATA1. Connect a second optical drive to the next available
(unpopulated) SATA connector following the numbered sequence of the connectors.
If you are installing a diskette drive, connect it to the connector on the system board labeled
FLOPPY.
If your are installing a media card reader, connect the USB cable to the USB system board
connector labeled MEDIA. If the media card reader includes a 1394 port, connect the 1394 cable
to the 1394 PCI card.
Refer to
connectors.
8. Reconfigure the computer, if necessary. Refer to the Computer Setup (F10) Utility Guide for
instructions on using Computer Setup.
92 Chapter 7 Removal and Replacement Procedures Convertible Minitower (CMT) Chassis
If you are installing a third optional drive, you may need to remove the strap that bundles
Connecting the Drive Cables (Optical Drive shown)
If you are installing a SATA optical drive, connect the first optical drive to the white SATA
System Board Drive Connections on page 85 for an illustration of the system board drive