Dell
13 Rack Information
13.1 Overview
The ReadyRails™ static rail system for the R210 provides tool-free support for racks
with square or unthreaded round mounting holes (including Dell's 42xx and 24xx series
racks) with an adjustment range of 60–87 cm. The rails also offer tooled mounting
support for 4-post threaded and 2-post (Telco) racks for added versatility.
13.2 Rails
The static rails for the R210 support tool-less mounting in 19"-wide, EIA-310-E
compliant square hole and unthreaded round hole racks via Dell's ReadyRails™
mounting interface. The rails also support a "generic" mounting interface for tooled
mounting in threaded hole and 2-post (Telco) racks. Screws are not included in the kit
since threaded racks are offered with a variety of thread designations. Users must
provide their own screws when mounting the rails in threaded or 2-post racks.
Table 23.
Rail
Mounting Interface
Identifier
A4
ReadyRails™/Generic
The adjustment range of the rails is a function of the type of rack in which they are
being mounted. The min-max values listed below represent the allowable distance
between the front and rear mounting flanges in the rack.
Rail
Mounting Interface
Identifier
A4
ReadyRails™/Generic
13.3 Cable Management Arm (CMA)
The static rails for the R210 support a wide variety of racks and mounting
configurations but do not support the ability to extend the system out of the rack for
service. Thus, they do not provide support for a cable management arm (CMA).
PowerEdge R210 Technical Guide
PowerEdge R210 Rail Information
Rail
Type
Square
Static
Yes
Figure 15. Rack Adjustability Range
Rail
Rack Adjustability Range (mm)
Type
Square
Min
Static
608
Rack Types Supported
4-Post
Round
Thread
Yes
Yes
Round
Threaded
Max
Min
Max
Min
879
594
872
604
2-Post
Flush
Center
Yes
Yes
Rail Depth
(mm)
Without
With
CMA
CMA
Max
890
622
—
52