Compaq 7470 - Presario - 64 MB RAM Maintenance And Service Manual page 11

MSG index Product Description
Home
Product Description
Models and features
CPU controls and
lights
Keyboard
Creativity Action
Center
Back components
Power cord
requirements
Maintenance and Service Guide
Compaq Presario 7400 Series Computers
Removal &
Replacement
PRODUCT DESCRIPTION
Power Cord Set Requirements
The power supply should be set based on the country where it purchased
and used. The voltage select switch feature should be set to 115 Volts AC
for the USA.
The power cord set (flexible cord and wall plug) received with the computer
meets the requirements for use in the country where the computer was
purchased.
Power cord sets for use in other countries must meet the requirements of
the country where you use the computer. For more information on power
cord set requirements, contact your Compaq authorized dealer, reseller, or
service provider.
General Requirements
The requirements listed below are applicable to all countries:
1 The length of the power cord set must be at least
6.00 feet (1.8 m) and no longer than 9.75 feet (3.0
m).
2 All power cord sets must be approved by an
acceptable accredited agency responsible for
evaluation in the country where the power cord set
will be used.
3 The power cord set must have a minimum current
capacity of 10A and a nominal voltage rating of 125
or 250 volts AC, as required by each country's
power system.
4 The appliance coupler must meet the mechanical
configuration of an EN 60 320/IEC 320 Standard
Sheet C13 connector for mating with appliance inlet
on the Switch Box.
Country-Specific Requirements
Country
Australia
Austria
Belgium
Canada
Denmark
Finland
France
Germany
* The flexible cord must be <HAR> Type HO3VV-F, 3-
conductor, 1.0 mm2 conductor size. Power cord set fittings
(appliance coupler and wall plug) must bear the
certification mark of the agency responsible for evaluation
in the country where it will be used.
** The flexible cord must be Type SJT-2 or equivalent, No.
18 AWG, 3-conductor. The wall plug must be a two-pole
grounding type with a NEMA 5-15P (15A, 125V) or NEMA 6-
15P (15A, 250V) configuration.
*** The appliance coupler, flexible cord, and wall plug
must bear a "T" mark and registration number in
accordance with the Japanese Dentori Law. Flexible cord
must be Type VCT or VCTF, 3-conductor, 0.75mm2
conductor size. The wall plug must be a two-pole type with
a Japanese Industrial Standard C8303 (15A, 125V)
configuration.
Troubleshooting
Jumper & Switch
Information
Accredited Agency
EANSW*
OVE*
CEBC*
CSA**
DEMKO*
SETI*
UTE*
VDE*
Illustrated Parts Catalog
Specifications
Country Accredited
Italy
Japan
Norway
Sweden
Switzerland
United
Kingdom
United States
ll ll
Agency
IMQ*
JIS***
NEMKO*
SEMKO*
SEV*
BSI*
UL**