3 Slide and remove the solid-state drive out of the system-board connector.
1
screw
3
solid-state drive
Replacing the Solid-State Drive
1 Align the notch on the solid-state drive with the tab in the
system-board connector.
CAUTION:
If you use excessive force, you may damage the connector.
2 Insert the solid-state drive connector at a 45-degree angle into the
system-board connector.
3 Replace the screw that secures the solid-state drive to the system board.
4 Adhere the tape over the solid-state drive.
Postrequisites
1 Replace the battery. See "Replacing the Battery" on page 18.
2 Replace the power-light board.
See "Replacing the Power-Light Board" on page 16.
3 Replace the base cover. See "Replacing the Base Cover" on page 14.
4 Follow the instructions in "After Working Inside Your Computer" on page 11.
28
Solid-State Drive
Use firm and even pressure to slide the solid-state drive into place.
2
system-board connector
1
2
3