Operating
instructions
Getting
Started
normal
casual
towels
_
c
C
_(_)
fast
,
dry
mixed
_[_O
O I_ delicate
Joad
heavy
_ _
C _-_- touch
duty
_'
up
bulky/
_o
_
time
bedding
dry
,@
my
time
control
favorite
dry
lock
Temperature
Dryness
Options
O
high
@ medium/high
()
max
O
medium
@
normal
C> low
©
less
©
air
O
damp
add
stearn
_
1_)
sanitize
This manual covers many models and not all cycles, options,
or features listed are available
on every model. Console shown
above for reference only. Your model may differ.
To operate
your dryer, follow
these
basic
steps:
1. Check and clean the lint screen. (See page 9.)
4. Select desired settings and options. (See page
2. Load the dryer. (See page 9.)
9, page 13, page 14 and pages 15-16.)
5. Start the dryer. (See page 9.)
3. Select the desired cycle. (See page 9, pages
10-12 and page 18.)
Normal
Operating
Sounds
You may or may not hear the following sounds
from your new dryer:
O
A. WATER VALVE (Steam models only.) The flow of
water is controlled by electric solenoids. During
operation there may be a clicking sound as the
valve opens and closes to control the water flow.
B. SUSPENSION
ROLLERS The dryer drum
is supported by a set of suspension rollers.
At times there may be a thumping or rolling
sound when the dryer starts. This may happen
if the dryer has not been in use for a period of
time, or after a heavy load has remained in the
dryer drum for an extended period, creating
a temporary flat spot on the edge of the
roller. The noise should dissipate as the dryer
operates and the flat spots smooth out.
f
k
C. AIR FLOW SYSTEM Your dryer is equipped
with a high volume air handling system. In
some installations there may be some sounds
associated with air movement throughout
the dryer, including the air duct, blower, and
exhaust system. This is normal and can vary
with load size and type.
D. GAS VALVE (Gas models only.) The flow of gas is
controlled by electric solenoids. During operation
there may be a clicking sound as the valve opens
and closes to control the gas flow.
E. GAS BURNER (Gas models only.) When the
burner is operating, there may be sounds
generated as the air flow mixes with the gas
flame. This noise is normal and will only occur
when the gas is ignited in the combustion tube.