Configure Nmea; Coordinate System Selection - Eagle IntelliMap 480 Installation And Operation Instructions Manual

, then use ↑ ↓ → ← to enter the station frequency, then
4. Press
ENT
press .
ENT
5. Press → to
B
then press
ENT
6. a. If you are not using a Starlink DGPS receiver, press
| |
EXIT EXIT EXIT
B. If you are using a Starlink DGPS receiver, press ↓ to
|press
T M
UNING ODE
vious page.

Configure NMEA

You can configure the unit to use specific NMEA sentences.
1. Press
MENU
2. Press ↓ to
C
3. a menu appears showing the prefixes of the available NMEA sen-
tences. a check mark next to a prefix means the prefix is in use. Use ↑ ↓
→ ← to select a prefix, then press
again to check the box and turn a prefix on.)
4. When the desired prefixes are checked or unchecked, press
| |
EXIT EXIT EXIT

Coordinate System Selection

The Coordinate System Menu lets you select the coordinate system to
use when displaying and entering position coordinates.
Menus for changing coordinate system used to display positions.
To get to Coordinate System Selection:
1. Press
MENU
then use ↑ ↓ to select the station bit rate,
|
R ENT
IT ATE
.
| to return to the previous page.
EXIT
|press
ENT
| |↓ to
MENU S
P
OMMUNICATIONS
| to return to the previous page.
EXIT
| |↓ to
MENU GPS S
| |
EXIT EXIT EXIT
|
S ENT
YSTEM ETUP
| |↓ to
ENT
ORT
to turn off the prefix. (Press
ENT
| .
ENT
ETUP
69
| to return to the pre-
EXIT
.
C NMEA
ONFIGURE
S A
TARLINK UTO
| .
ENT
ENT