Eagle FishElite 502c Installation And Operation Instructions Manual page 76

50 percent. At normal boating speeds, this automatically provides
enough return echoes to refresh the screen and scroll the chart at
maximum chart speed.
However, when you are running at high speeds, or just want the fastest
possible screen update, you may want to use the HyperScroll feature.
When you change the Ping Speed to any setting greater than 50 per-
cent, the unit automatically enters HyperScroll mode.
These faster ping rates allow you to maintain a high-detail picture on
the screen, and the screen refresh rate and chart scroll speed can keep
pace with the boat as it moves quickly over the bottom terrain.
When using HyperScroll, you may also need to manually decrease the
sensitivity for optimum performance. Depending on water depth and
other conditions, HyperScroll may cause a second bottom echo to return
to the transducer during the next ping cycle, or sounding. This can result
in a large amount of clutter appearing on the screen. If this occurs, just
decrease the sensitivity to a level that eliminates the clutter. When you
turn HyperScroll off, you can return to your original sensitivity level.
Sonar Menu with Ping Speed selected (left).
Ping Speed Control Bar at default setting (right).
To change Ping Speed:
1. From the Sonar Page, press |↓ to | .
MENU P S ENT
ING PEED
2. The Ping Speed Control Bar appears. Press ↑ ↓ to adjust the ping speed.
When it is set at the desired level, press .
EXIT
To turn off HyperScroll:
1. From the Sonar menu, press ↓ to
| .
P S ENT
ING PEED
2. The Ping Speed Control Bar appears. Press ↓ to decrease ping speed
to 50 percent. When it's set at the desired level, press .
EXIT
68