Installing The Water Filter; Removing Residual Matter Inside Water Line - Samsung RFG23UERS User Manual

• 6.35mm compression nut
• plastic tubing
Refrigerator Refrigerator
Plastic tubing
(Supplied)
Ferrule
(Not supplied)
Copper tubing
(Not supplied)
Household water line
1. Slip the compression nut through the supplied
plastic tubing .
2. Tighten the compression nut
6.35mm compression fi tting.
- If you are using copper tubing, slip the
compression nut (not included) and ferrule
(not included) on copper tubing (not included) as
shown.
- If you are using plastic tubing
molded end(Bulb) of the plastic tubing
the compression fi tting.
Do not use without the molded end(Bulb) of
the plastic tubing .
3. Tighten the compression nut
compression fi tting. Do not over-tighten the
compression nut .
4. Turn water on and check for any leakage.
Only connect the water line to a drinkable
water source. If you have to repair or
disassemble the water line, cut off 6.35mm of the
plastic tubing to make sure you get a snug, leak-
free connection.
Installing the water fi lter.
1. Remove the water fi lter cover
2. Remove the fi xed cap by turning it counter
clockwise. Keep the cap in a safe place for later
use if you don't use the fi lter.
3. Remove the water fi lter from the box and put
a replacement indicator sticker on the fi lter as
shown. Place the sticker on the fi lter that dates
six months in the future. For example, if you
install the water fi lter in March, put the "SEP"
sticker on the fi lter to remind you to replace it
in September. That way you'll know when it is
time to replace the fi lter. Normally, a fi lter life is
about 6 months.
• copper tubing
• ferrule
Compression nut
(6.35mm) (Supplied)
Compression fi tting
(Supplied)
Bulb
Compression nut
(6.35mm) (Not
supplied)
Plastic tubing
or
(Not supplied)
4. Remove the fi lter cap and insert the fi lter into
5. Slowly turn the water fi lter 90º clockwise to
onto the
, insert the
into
onto the
Removing any residual matter inside
the water supply line after installing
.
1
the water fi lter.
1. Turn ON the main water supply & turn OFF the
2. Run water through the dispenser until the water
3. Additional fl ushing may be required in some
4. Open the Refrigerator door and make sure
2
Sticker
(month indicator)
the fi lter housing.
align with the printing mark on the cover,
locking the fi lter in position.
Make sure to align the water fi lter label mark
with center of cover fi lter printing as illustrated.
Remember, do not overtighten.
Cover fi lter
4
Separation
of red cap.
You should remove the right side upper
glass shelf before installing the water fi lter.
valve to the water supply line.
runs clear (approx. 6-7minutes). This will clean
the water supply system and remove air from
the lines.
households.
there are no water leaks coming from the water
fi lter.
Be sure to fl ush the dispenser thoroughly
or water may leak from it. This is due to the
fact that there is still air in the line.
1
3
5
Turn until
the label is
aligned.
_11
Setting up