Installing The Water Dispenser Line; Connecting To The Water Supply Line; Connecting The Water Supply Line To The Refrigerator - Samsung RF265A Series User Manual

1. Pull out the freezer drawer ( 1 ), then you can
see the lower hinge ( 2 ).
2. Insert a philips screwdriver (+) ( 3 ) into the
shaft ( 4 ) of the lower hinge.
3. Adjust the height by turning a philips
screwdriver (+) ( 3 ) clockwise (
counterclockwise (
• When you turn a philips screwdriver (+)
counterclockwise (
move up.
1
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator. To help promote
better health, the water filter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20~125psi (138~862 kPa) is required.
If the refrigerator is installed in an area with low
water pressure (below 20psi), you can install
a booster pump to compensate for the low
pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly filled. To do this, press the water
dispenser lever until the water runs from the water
outlet.
• Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper
tubing and a ¼" compression nut.
• Use the new hose-sets supplied with the
DA68-02601A-16.indb 13
) or
DOWN
UP ).
), the door will
UP
2
4
3 3
appliance only. Do not re-use an old hose set.
Keep ventilation openings, in the
appliance enclosure or in the built-in
WARNING
structure, clear of obstruction. Connect
to potable water supply only.

Connecting to the water supply line

1. First, shut off the main water
supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
Cold water line
Pipe clamp
Shut off valve
3. Connect the water line installation kit to the
shut off valve.
Cold water line
Pipe clamp
Shut off valve
Connecting the water supply line to
the refrigerator.
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
Use Copper Tubing
• ¼" copper tubing • ¼" plastic tubing
• ¼" compression nut (1pc)
• Ferrule (2pc) • ¼" compression nut (1pc)
Water line installation kit
Use Plastic Tubing
- Molded end(Bulb)
setting up _13
2018. 10. 8. 오후 4:32