Battery Recharge - Panasonic KX-TG4734B Operating Instructions Manual

Battery recharge

Problem
The handset beeps and/or
flashes.
I fully charged the batteries, but
– still flashes,
– is displayed, or
– the operating time seems to
be shorter.
Making/answering calls, intercom
Problem
is displayed.
Noise is heard, sound cuts in
and out.
The handset does not ring.
The base unit does not ring.
I cannot make a call.
I cannot make long distance
calls.
For assistance, please visit http://www.panasonic.com/help
Cause/solution
R Battery charge is low. Fully charge the batteries (page 11).
R Clean the battery ends (
with a dry cloth and charge again.
R It is time to replace the batteries (page 11).
Cause/solution
R The handset is too far from the base unit. Move closer.
R The base unit's AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 31).
R You are using the handset or base unit in an area with
high electrical interference. Re-position the base unit and
use the handset away from sources of interference.
R Move closer to the base unit.
R If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base unit and
the telephone line jack. Contact your DSL/ADSL provider
for details.
R The ringer volume is turned off. Adjust the ringer volume
(page 18).
R Silent mode is turned on. Turn it off (page 29).
R The ringer volume is turned off. Adjust the ringer volume
(page 18).
R The dialing mode may be set incorrectly. Change the
setting (page 16).
R Make sure that you have long distance service.
Useful Information
, ) and the charge contacts
49