Communication Specification; Communication Parameter; Rs-232C Remote Control; Lan Control - NEC MultiSync V422 Control Manual

III. Communication specification

3. Communication Parameter

3.1 RS-232C Remote control

(1) Communication system
(2) Interface
(3) Baud rate
(4) Data length
(5) Parity
(6) Stop bit
(7) Communication code

3.2 LAN control

(1) Communication system
(2) Interface
(3) Communication layer
(4) IP address
(5) Port No.
(Note)
The monitor will disconnect the connection if no packet data is received for 15 minutes.
And the controller (PC) has to re-connect to control the monitor again, after 15 minutes or more.

3.3 Communication timing

The controller should wait for a packet interval before next command is sent.
The packet interval needs to be longer than 600msec for the LCD monitor.
Asynchronous
RS-232C
9600bps
8bits
None
1 bit
ASCII
TCP/IP (Internet protocol suite)
Ethernet (CSMA/CD)
Transport layer (TCP)
* Using the payload of TCP segment.
(Default) 192.168.0.10
* If you need to change,
Please refer "Network settings" on User's manual.
7142 (Fixed)
(5/71)