Download  Print this page

Date & Time Read And Write; Date & Time Read - NEC MultiSync V422 Control Manual

External control.
Hide thumbs

Advertisement

9. Date & Time read and write
9.1 Date & Time Read
This command is used in order to read the setting of Date & Time.
1) The controller requests the monitor to reply with the Date & Time.
SOH-'0'-Monitor
ID-'0'-'A'-'0'-'6'
Header
SOH (01h): Start Of Header
'0' (30h): Reserved
Monitor ID: Specify the Monitor ID of which you want to get status.
'0' (30h): Message sender is the controller.
'A' (41h): Message type is "Command".
'0'-'6'(30h, 36h): Message length
Message
STX (02h): Start of Message
'C'-'2'-'1'-'1' (43h, 32h, 31h, 31h): Date & time read request command.
ETX (03h): End of Message
Check code
BCC: Block Check Code
Refer to the section 4.5 "Check code" for a BCC calculation.
Delimiter
CR (0Dh): End of packet
2) The monitor replies Date & Time to the controller.
Header
SOH-'0'-'0'-Monitor ID-'B'-'1'-'4'
Header
SOH (01h): Start of Header
'0' (30h): Reserved
'0' (30h): Message receiver is the controller
Monitor ID: Indicate a replying Monitor ID
'B' (42h): Message type is "Command reply"
'1'-'4'(31h, 34h): Message length
Message
STX (02h): Start of Message
'C'-'3'-'1'-'1' (43h, 33h, 31h, 31h): Date & Time read reply command
'YY'-'MM'-'DD'-'WW'-'HH'-'MN'-'DS': Date & Time data
YY: Year (offset 2000)
'0'-'0'(30h, 30h): 2000
'6'-'3'(36h, 33h): 2099 (99 = 63h)
MM: Month
'0'-'1'(30h, 31h): January
'0'-'C'(30h, 43h): December
DD: Day
Header
Ex.) If Monitor ID is '1', specify 'A'.
STX-'C'-'3'-'1'-'1'-YY-MM-DD-WW-HH-MN
-DS-ETX
Ex.) When this byte is set to 'A', the replying Monitor ID is '1'.
|
|
'0'-'1'(30h, 31h): 1
|
'1'-'E'(31h, 45h): 30(=1Eh)
'1'-'F'(31h, 46h): 31(=1Fh)
Message
STX-'C'-'2'-'1'-'1'-ETX
Message
(43/71)
Check code
Delimiter
BCC
CR
Check code
BCC
Delimiter
CR

Advertisement

Table of Contents

   Also See for NEC MultiSync V422

   Related Manuals for NEC MultiSync V422

Comments to this Manuals

Symbols: 0
Latest comments: