Get Timing Report And Timing Reply - NEC MultiSync V422 Control Manual

5.5.2 Get Timing Report and Timing reply.

The controller requests the monitor to report the displayed image timing.
Command code
STX
'0' '7'

Send "07"(30h, 37h) as Get Timing Report command.

Complete "Get Timing Report" command packet as follows;
ASCII: 01h-30h-41h-30h-41h-30h-34h-02h-30h-37h-03h-CHK-0Dh
SOH-'0'-'A'-'0'-'A'-'0'-'4'-STX-'0'-'7'-ETX-CHK- CR
The monitor replies status as the following format;
Command
STX
'4' 'E'

SS: Timing status byte
Bit 7 = 1: Sync Frequency is out of range.
Bit 6 = 1: Unstable count
Bit 5-2
Bit 1
Bit 0

H Freq: Horizontal Frequency in unit 0.01kHz

V Freq: Vertical Frequency in unit 0.01Hz
Ex.) When H Freq is '1''2''A''9' (31h, 32h, 41h, 39h), it means 47.77kHz.
ETX
SS
Hi Lo MSB
Reserved (Don't care)
1:Positive Horizontal sync polarity.
0:Negative Horizontal sync polarity.
1:Positive Vertical sync polarity.
0:Negative Vertical sync polarity.
H Freq.
LSB MSB
(18/71)
V Freq.
ETX
LSB