Commands; Save Current Settings - NEC MultiSync V422 Control Manual

5.5 Commands

"Command message format" depends on each command
section 7 to 13.

5.5.1 Save Current Settings.

The controller requests for the monitor to store the adjusted value.
Command code
STX
'0'

Send "OC"(30h, 43h) as Save current settings command.

Complete "Save Current setting" command packet as follows;
ASCII: 01h-30h-41h-30h-41h-30h-34h-02h-30h-43h-03h-CHK-0Dh
SOH-'0'-'A'-'0'-'A'-'0'-'4'-STX-'0'-'C'-ETX-CHK- CR
The monitor replies the packet for confirmation as follows;
SOH-'0'-'0'-'A'-'B'-'0'-'6'-STX-'0'-'0'-'0'-'C'-ETX-CHK- CR
ETX
'C'
.
Some commands are shown with usage. Refer to
(17/71)