Table of Contents
Advertisement
36
Installation
•
IEEE802.1x:
-
Disable: Not used with this function.
-
Enable: Select this option to 802.1x user authentication. If you select this option, identity, password and EAP method options are
enabled.
•
Identity: Enter the identity name given to you by your IT administrator. This specifies the system's identity used for 802.1X authentication.
•
Password: Enter the password given to you by your IT administrator. This specifies the system's password used for 802.1X authentication.
•
EAP Method: Select the EAP method.
NOTE
When User Use EAP-MD5
If you use EAP-MD5, you do not need to upload any files in the web service.
3
When User Use EAP-TTLS
1. If you use EAP-TTLS, you must receive ca.pem, client.pem, client.key from the 802.1x network manager.
2. Upload the ca.pem, client.pem, client.key files to the web service of your system as shown in the picture below.
When User Use EAP-PEAP
1. If you use EAP- PEAP, you must receive a ca.pem file from the 802.1x network manager.
2. Upload the ca.pem file to the web service of your system as shown in the picture below.
After Setting 802.1x
1. When you finish these settings, confirm that you can see your IP on the main screen.
2. Perform a ping test in the system info > Network utility > Command.
3. You can now attempt to call other VCS systems.
Advertisement
Table of Contents
