Advertisement
4
Turn the focus ring to sharpen the image.
5
If your image looks like
one side of the screen at an angle. Place the projector directly in front of
the center of the screen, facing the screen squarely. Or use the horizontal
keystone slider on the projector to correct it.
6
Your projector automatically adjusts images that look like
but if necessary you can press the
correct this.
Using the remote control
Make sure the batteries are installed as shown (two AA batteries).
Turn projector on
Switch between
2D and 3D
Access projector
menus
Control WirelessHD
functions
For more information on using the remote control, see the online User's Guide.
or
, you've placed the projector off to
or
or
buttons on the projector to
Turn projector off
Choose which source
to display
Navigate projector
menus
Turn off projector
display
Viewing 3D images
To view 3D content, you must first connect a 3D-compatible video device to
one of the HDMI ports on your projector. You will also need a pair of EPSON
or EPSON-compatible RF 3D active shutter glasses.
1
Turn on and begin playback on the 3D-compatible video device.
2
Press the
button on the projector remote control, if necessary.
3
Slide the power switch on your 3D glasses to the On position.
Note: If the glasses don't automatically display 3D content, you may
need to pair them with the projector. Move the glasses within 10 feet
(3 m) of the projector, then press and hold the Pairing button on the
3D glasses for at least 3 seconds. The status light on the glasses will
alternately flash green and red, then remain green for 10 seconds if
,
pairing is successful.
See the online User's Guide for more information on adjusting the 3D images.
Connect the WirelessHD
Transmitter
Follow these steps to set up the included WirelessHD Transmitter.
1
Place the transmitter within 32 feet (10 m) of the projector. Make sure
the front of the transmitter faces the front of the projector. See the
online User's Guide for more information on the WirelessHD transmission
range.
Note: Do not place the transmitter on a metal surface, as this may
interfere with the signal. Make sure there are no obstructions between
the transmitter and the projector.
2
Plug the AC adapter into the transmitter and a wall outlet.
Advertisement
