Epson AcuLaser C3900N User Manual page 54

Items
FINE LINE ADJ
AIDC MODE
THICK MODE
MAIN SCAN MAIN SCAN PAGE
ADJUST
SCAN
ADJUST
VALUE
SUPPLIES REPLACE
YELLOW/MAGENTA/CYAN
FUSER UNIT
AcuLaser C3900 Series
Settings (default in bold)/Description
-3-0-2
Adjust how fine lines are reproduced by changing
the applied voltage (VC) to the electrostatic roller.
MODE 1/ MODE 2
Select the AIDC operation mode.
MODE 1: Standard mode
MODE 2: Low mode
QUALITY MODE/SPEED MODE
In order to prevent toner from clogging within the
developer unit as a result of it being driven at
half-speed, select the timing for driving the
developer unit at full speed for a fixed length of
time when thick paper is being fed.
QUALITY MODE: While printing on thick paper,
printing is periodically paused, and the developer
unit is driven at full speed for a fixed length of time.
Since printing is paused, the quality is not affected;
however, a standby time of approximately 70
seconds occurs every 400 seconds or so of
half-speed operation.
SPEED MODE: While printing on thick paper, only
the drive of the developer unit periodically
switches to full speed for a fixed length of time.
Since printing continues during full-speed drive,
the print quality is slightly affected, however the
standby time is short.
PRINT/CANCEL
Print the test pattern for fine adjustment of the
color ratios in the main scanning direction.
42 - 0 - -42
Finely adjust the ratio of yellow/magenta/cyan in
the main scanning direction.
YES/NO
Resets the fuser unit counter.
Printer Control Panel and Configuration Menu
User's Guide
54