2.7.4
Installing ASUS PIKE Riser Card (optional)
Follow the steps below to install the optional ASUS PIKE SAS RAID card to the
ASUS PIKE riser card.
1.
Remove the three screws on the
riser card bracket, as shown in the
right figure.
2.
Firmly hold the riser card bracket,
and then pull it up to detach it from
the PCI Express x16 slot on the
motherboard.
3.
Locate the two screws on the riser
card bracket, then remove the
screws from the bracket.
4.
Locate the two screw holes on the
PIKE riser card.
5.
Secure the PIKE riser card to the
riser card bracket with two screws.
2-24
Chapter 2: Hardware setup