Reversing The Door Hinge - Asko T712C Use And Care Manual

Reversing the door hinge

The tumble dryer comes with the door
hinged on the left side. However, it is pos-
sible to change the door to be hinged on the
right.
Proceed as follows:
1. Remove the lower front plate and undo
the three screws holding the hinge attach-
ment.
2. Angle the lower edge of the door out to
the left while turning the hinge attachment
as indicated by the arrows.
Hinge attachment
3. Move the hinge pin. To hinge the door on
the right side, the hinge attachment must
then be turned upside down.
Hinge pin
4. Then move the hinge pin in the panel's
lower edge.
5. Next you must move the plastic plugs on
the upper and lower edges of the door. Use
a flat screwdriver.
6. Unscrew the two screws on the sides of
the door, around a quarter inch (five mil-
limeters), to allow the door magnet and
cover washer on the inside of the door to
be removed.
7. Then remove the door magnet (1) and
cover washer (2).
1
2
8. Insert the door magnet in place of the
cover washer.
Custumer Care Center
1-800-898-1879
www.askousa.com
23