Troubleshooting - Asko T712C Use And Care Manual

Troubleshooting

The machine will not start
Check
• that the outer door is properly closed.
• that the main power switch is pressed.
• that you have set the program correctly.
• that the Delayed Start option has not been
selected. If so, the time remaining until start
will be shown in full hours in the display
(e.g. 5, 4, 3h) .
• that any plug is connected.
• that your home's fuses (circuit breakers)
are intact, swap two circuit breakers. You
cannot always tell from outside if a circuit
breaker is broken.
• that the overheating cut-off has not been
triggered (see below).
Overheating cut-off
The overheating cut-off shuts off the tumble
dryer if the temperature is too high, caused
by lint clogging the lint filter, for instance.
• Clean the filter.
• Check to see if the lint filter is dirty and
clean it if necessary. See "Care and clean-
ing".
• The overheating cut-off will reset automat-
ically once the machine has cooled.
Drying takes too long
• Check that neither the lint filter nor the
condenser are clogged. See "Care and
cleaning".
• Prolonged drying times may also be due
to the condenser dryer being placed in a
room that is too small and the air in the
room (cooling air) being too hot.
• Make sure that the tumble dryer has ac-
cess to more cold air, by opening doors
and/or windows, for example.
Error messages
• If F1 flashes in the display, the condenser
drain hose could be blocked.
Remove the hose from the drain and check
for obstructions. The hose should be in-
serted no more than 5 or 6 inches into the
wall drain.
• If F2 flashes in the display, the maximum
permitted program time has been reached.
For remedial action, read "Drying takes too
long" in the "Troubleshooting" section.
Custumer Care Center
1-800-898-1879
www.askousa.com
15