Electrical Installation; Condensed Water - Asko T712C Use And Care Manual

Adjusting the feet
Screw the feet in or out so that the tumble
dryer is steady and balanced on the floor or
on the washing machine. Then tighten the
locking nuts.
Locking nut

Condensed water

Install the dryer so the condensed water will
continuously flow into a drain or sink. To do
this, follow the instructions below:
1.Disconnect the short hose (1) from the blue
connection. (It's okay to let the hose hang
down.)
2.Connect the rubber hose supplied with the
dryer to the blue nipple (2).
3.Run the hose to a drain or sink, as illustrat-
ed.
NOTE:
The drain hose must not be more than 40"
above the floor.
2
1
3

Electrical installation

WARNING!
This appliance must be properly grounded.
Refer to the "Important Safety Instructions"
on page 2 for grounding instructions.
The power supply cord must be grounded.
If the machine is to be used in a wet area,
the supply must be protected by a residual
current device.
Connection to a permanently wired sup-
ply point must be made only by a qualified
electrician.
As supplied:
Single-phase,
230 V, 60 Hz, 2500 Watt heater rating 30 A
fuse required
WARNING:
The receptacle on the rear of the machine
is designed to accommodate ASKO wash-
ers ONLY (rated 208–240 V.) To use this
receptacle, you must use the ready-fitted
plug supplied with the washing machine or
an equivalent.
ASKO washers rated 208–240 V have two
internal fuses of 15 A each.
3
Note:
In Canada, the dryer is delivered ready-fit-
ted with a four-prong plug intended for con-
nection to a single-phase supply.
Custumer Care Center
1-800-898-1879
www.askousa.com
Remove cover to access terminal
box. (Requires a 20-Torx screwdriver.)
21