Reversing The Door - Asko T712C Operating Instructions Manual

Reversing the door

Reversing the door
The tumble dryer comes with the door hinged on
the left. However, it is possible to change the door
to be hinged on the right.
Follow these instructions:
1. Remove the lower front plate and undo the
three screws holding the hinge attachment.
2. Angle the lower edge of the door out to the left
while turning the hinge attachment as indicated
by the arrows.
Hinge attachment
3. Move the hinge pin. To hinge the door on the
right, the hinge attachment must be turned
upside down.
Hinge pin
4. Then move the hinge pin in the panel's lower
edge.
5. Next you must move the plastic plugs on the
upper and lower edges of the door. Use a flat
screwdriver.
6. Unscrew the two screws on the sides of the
door by about a quarter inch to allow the door
magnet and cover washer on the inside of the
door to be removed.
7. Then remove the door magnet (1) and cover
washer (2).
1
2
8. Insert the door magnet in place of the cover
washer.
Customer Care Center
1-800-898-1879
www.askousa.com
27