Care And Maintenance Instructions; Cleaning The Lint Filter; Cleaning The Outside Of The Machine - Asko T712C Operating Instructions Manual

Care and maintenance instructions

Cleaning the lint filter

The lint filter must be cleaned after each load. If
you have very hard water, this can cause
limescale deposits in the lint filter. Check for any
limescale deposits when cleaning the lint filter
and, if necessary, wash the filter by hand. Addi-
tionally, the filter should be cleaned with hot water,
detergent, and a soft brush quarterly.
1. Grasp the filter handle and pull it toward you.
2. Pull the filter out of its holder.
3. Open the filter and remove the lint from all
sides of it by hand. Use a soft, dry cloth to re-
move any deposits.
4. Replace the filter in its holder.
Note!
If you have hard water, the filter should be washed
with water to remove any limescale deposits. Use
a sponge and a little dishwashing detergent if
necessary. Dry the filter carefully with a towel. If
you cannot remove the limescale, you can buy a
new filter from the retailer where you bought the
tumble dryer.

Cleaning the outside of the machine

Clean the outside of the machine and the program
panel with a mild cleaner. Do not use solvents,
as these can damage the machine. Do not hose
down or spray the machine with water.
Note!
Do not allow dust to accumulate around the ma-
chine. Keep the area around the tumble dryer
clean and cool; dust, heat, and moisture prolong
drying times.
Customer Care Center
1-800-898-1879
www.askousa.com
15