Adjusting The Feet; Condensed Water; Electrical Installation - Asko T712C Operating Instructions Manual

Installation instructions

Adjusting the feet

Screw the feet in or out so that the tumble dryer
is steady and balanced on the floor or on the
washing machine. Then tighten the lock nuts.
Lock nut

Condensed water

Install the dryer so the condensed water will con-
tinuously flow into a drain or sink. To do this, fol-
low the instructions below:
1. Disconnect the short hose (1) from the blue
connection. (It's okay to let the hose hang
down.)
2. Connect the rubber hose supplied with the
dryer to the blue nipple (2).
3. Run the hose to a drain or sink, as illustrated
(3).
Note
The drain hose must not be more than 40" above
the floor.
2
1
2a
24
Maximum
height 40"
Customer Care Center
1-800-898-1879
www.askousa.com

Electrical installation

Warning!
The receptacle on the rear of the machine is de-
signed to accommodate ASKO washers ONLY
(rated 208–240 V.) To use this receptacle, you
must use the ready-fitted plug supplied with the
washing machine or an equivalent.
ASKO washers rated 208–240 V have two internal
fuses of 15 A each.
The machine should only be connected to a
grounded wall socket.
Warning!
This appliance must be properly grounded. Refer
to the "Important Safety Instructions" for grounding
instructions.
The power supply cord must be grounded. If the
machine is to be used in a wet area, the supply
must be protected by a residual current device.
Connection to a permanently wired supply point
must be made only by a qualified electrician. As
supplied: Single-phase, 230 V, 60 Hz, 2500W
heater rating 30 A circuit required
Remove cover to
access terminal box.
(Requires a 20-Torx
screwdriver.)