Electrical Installation - Asko T712 Operating Instructions Manual

Installation instructions
To connect the exhaust duct to a
ventilation outlet, follow the steps below:
1. Connect the exhaust duct to a ventilation ex-
haust fitting or to a discharge through the wall.
2. Secure the duct joint to the outlet stub on the
machine.
3. Run the duct with as few bends as possible to
the point of discharge.
Ventilation grill
Warning!
This appliance shall not be exhausted into a
chimney, a wall, a ceiling, an attic, a crawl space
or a concealed space of a building. Only a rigid
or flexible metal duct shall be used for exhausting.
Only a metal ventilation grill shall be used. If the
duct is taken to a wall outlet, a ventilation grill shall
be fitted to prevent reverse flow of cold air. Fit the
ventilation grill to the outside or inside of the wall.
If there is only one vent
duct from the room, a
vent spacer must be fitted.
Vent spacer
Make sure nothing is
blocking the ventill
Customer Care Center
1-800-898-1879
www.askousa.com

Electrical installation

Warning!
The receptacle on the rear of the machine is de-
signed to accommodate ASKO washers ONLY
(rated 208–240 V.) To use this receptacle, you
must use the ready-fitted plug supplied with the
washing machine or an equivalent.
ASKO washers rated 208–240 V have two internal
fuses of 15 A each.
The machine should only be connected to a
grounded wall socket.
Warning!
This appliance must be properly grounded. Refer
to the "Important Safety Instructions" for grounding
instructions.
The power supply cord must be grounded. If the
machine is to be used in a wet area, the supply
must be protected by a residual current device.
Connection to a permanently wired supply point
must be made only by a qualified electrician. As
supplied: Single-phase, 230 V, 60 Hz, 3000W
heater rating 30 A circuit required
Remove cover to
access terminal box.
(Requires a 20-Torx
screwdriver.)
25