Adjusting The Feet; Air Exhaust - Asko T712 Operating Instructions Manual

Installation instructions

Adjusting the feet

Screw the feet in or out so that the tumble dryer
is steady and balanced on the floor or on the
washing machine. Then tighten the lock nuts.
Lock nut

Air exhaust

Connecting the exhaust duct to the dryer
Note
You will need to purchase a UL-CSA-approved
4-inch ridged metal exhaust duct. The dryer is
delivered with the stub pipeattached to the rear
exhaust outlet, but the exhaust duct can be at-
tached to either the right or left exhaust outlet.
Asko dryers have a
"T-stile" exhaust vent that
allows you to connect the
duct on the rear or on the
left or right side
.
Side Exhaust Outlet
The duct must not be assembled with screws or
other fastenings that extend into the duct and trap
lint.
Vent
T-tube
Rear Exhaust Outlet
Stub Duct
Clamp
(not supplied)
Customer Care Center
1-800-898-1879
www.askousa.com
To connect the exhaust duct to the rear
outlet
To connect the exhaust duct to the rear outlet,
follow the steps below:.
1. Push the duct onto the stub pipe and secure it
with a clamp
2. With the duct attached, insert the stub pipe into
the hole. It should snap into place.
3. After you push the dryer into place, check for
kinks in the duct.
Note
Excessive duct length and too many bends can
impede drying performance. We recommend that
you cut off any excess exhaust duct and run the
duct with as few bends as possible. Make any
necessary bends as gentle as possible.
Note
Maximum duct length of 60 feet and 4 elbows is
allowed. Subtract 4 feet of duct for each 90° el-
bow.
23