Asko T712 Operating Instructions Manual page 21

Installation instructions
C. Built-in
ASKO dryers can be installed beneath a cabinet
or worktop with a minimum height of 34" (864
mm). There must be a gap of about 1/2" (12 mm)
all around the machine, including between the
rear edge of the machine top panel and the back
wall. The opening width must be at least 24-1/2"
(622 mm). The condensing models work best
when they have good air circulation. Install the
dryer so the condensed water will continuously
flow into a drain or sink, you will need a drain
outlet behind the unit. The maximum drain height
is 40" (1016 mm).
Notes
The height adjustment for the dryer is 33-1/2" to
34-1/2" (850 mm to 876 mm). Do not raise it
higher than 34-1/2" (876 mm). Hole measure-
ments are from center of hole.
Customer Care Center 21
1-800-898-1879
www.askousa.com