Removing The Microprocessor Thermal-Cooling Assembly - Dell Latitude D600 Service Manual

Microprocessor Thermal-Cooling Assembly: Dell Latitude D600 Service Manual
Back to Contents Page
Microprocessor Thermal-Cooling
Assembly
Dell™ Latitude™ D600 Service Manual
Removing the Microprocessor Thermal-Cooling
Assembly
CAUTION:
instructions in your System Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as
the back panel) on the computer.
NOTICE: Disconnect the computer and any attached devices from electrical
outlets, and remove any installed batteries.
1. Follow the instructions in
2. Remove the keyboard.
NOTE: You can remove the microprocessor thermal-cooling assembly with the
fan attached.
3. Loosen in consecutive order the four captive screws, labeled "1" through "4,"
that secure the microprocessor thermal-cooling assembly to the system board.
file:///F|/Service%20Manuals/Dell/Latitude/d600/thermal.htm (1 of 3) [2/28/2004 8:15:50 AM]
Before performing the following procedures, read the safety
"Preparing to Work Inside the Computer."