Time Required For A Rebuild; Failure Of Another Drive During Rebuild; Drive Failure In A Netware Environment - HP 418800-B21 - StorageWorks Modular Smart Array 70 Storage Enclosure User Manual

or rebuild. If fault tolerance is compromised, this data cannot be reconstructed and is likely to be
permanently lost.
If another drive in the array fails while fault tolerance is unavailable during rebuild, a fatal system
error may occur, and all data on the array is then lost. In exceptional cases, however, failure of
another drive need not lead to a fatal system error. These exceptions include:
• Failure after activation of a spare drive.
• Failure of a drive that is not mirrored to any other failed drives (in a RAID 1+0 configuration).
• Failure of a second drive in a RAID 6 with ADG configuration.

Time required for a rebuild

The time required for a rebuild varies considerably, depending on several factors:
• The priority that the rebuild is given over normal I/O operations (you can change the priority setting
by using ACU)
• The amount of I/O activity during the rebuild operation
• The rotational speed of the disk drives
• The availability of drive cache
• The brand, model, and age of the drives
• The amount of unused capacity on the drives
• The number of drives in the array (for RAID 5 and RAID 6 with ADG)
Allow approximately 15 minutes per gigabyte for the rebuild process to be completed. This figure is
conservative, and newer drive models usually require less time to rebuild.
System performance is affected during the rebuild, and the system is unprotected against further drive
failure until the rebuild has finished. Therefore, replace drives during periods of low activity when
possible.
CAUTION:
If the Online LED of the replacement drive stops blinking and the amber fault LED glows, or if other
drive LEDs in the array go out, the replacement drive has failed and is producing unrecoverable disk
errors. Remove and replace the failed replacement drive.
When automatic data recovery has finished, the online LED of the replacement drive stops blinking
and begins to glow steadily.

Failure of another drive during rebuild

If a non-correctable read error occurs on another physical drive in the array during the rebuild process,
the Online LED of the replacement drive stops blinking and the rebuild abnormally terminates.
If this situation occurs, restart the server. The system may temporarily become operational long enough
to allow recovery of unsaved data. In any case, locate the faulty drive, replace it, and restore data
from backup.

Drive failure in a NetWare environment

Use CPQONLIN to identify and monitor drive failure status in a NetWare environment.
70 Modular Smart Array User Guide 37