Remove the screws on the backplane (1).
5.
Tilt the backplane up from the bottom and lift it out of the chassis (2).
6.
Installing the backplane
To install the backplane, reverse the removal procedure:
Insert the backplane into the chassis, securing it with the screw.
1.
Install the midplane, riser board, 7-segment display board, I/O module and blank, fans, and power
2.
supplies.
Install the access panel.
3.
Insert the enclosure into the rack and power up the enclosure.
4.
Verifying component replacement
After replacing the backplane, check the hard drive status LEDs.
Removal and replacement procedures 57