Powering Down; Access Panel; Removing The Access Panel - HP 418800-B21 - StorageWorks Modular Smart Array 70 Storage Enclosure Maintenance And Service Manual

Complete server hardware installation and cabling. See the server documentation.
1.
Connect the SAS cables and power cords to the enclosure.
2.
Press and hold the Power On/Standby button on the enclosure. Wait and observe the system power
3.
LED and fan modules. When the enclosure powers up, the system power LED illuminates solid green
and the fans spin to a high speed, and then spin down to a low speed.
Power up the servers. See the server documentation.
4.

Powering down

To power down the enclosure:
Power down any attached servers. See the server documentation.
1.
Press the Power On/Standby button on the enclosure.
2.
Wait for the system power LED to go from green to amber.
3.
Disconnect the power cords.
4.
The system is now without power.

Access panel

Removing the access panel

Power down the enclosure:
1.
Power down any attached servers. See the server documentation.
a.
Press the Power On/Standby button on the enclosure.
b.
Wait for the system power LED to go from green to amber.
c.
Disconnect the power cords.
d.
Extend or remove the enclosure from the rack in which it may be installed:
2.
Loosen the front panel thumbscrews that secure the enclosure faceplate to the front of the rack.
a.
Disconnect the cabling and extend or remove the enclosure from the rack.
b.
Lift the access panel latch on top of the enclosure (1) and slide the access panel to the rear (2).
3.
Remove the access panel.
4.
Removal and replacement procedures 26