Important Safety Notes; Site Preparations; Operator Preparation - Chamberlain H Owner's Manual

Logic control (ver. 2.0) industrial duty door operator

Hide thumbs Also See for H:

Owner's manual (40 pages)

Replacement parts (4 pages)

Quick start manual (2 pages)

Table Of Contents

Table of Contents

CAUTION

TO AVOID DAMAGE TO DOOR AND OPERATOR,

MAKE ALL DOOR LOCKS INOPERATIVE. SECURE

LOCK(S) IN "OPEN" POSITION.

IF THE DOOR LOCK NEEDS TO REMAIN

FUNCTIONAL, INSTALL AN INTERLOCK SWITCH.

DO NOT CONNECT ELECTRIC POWER UNTIL

INSTRUCTED TO DO SO.

It is imperative that the wall or mounting surface

provide adequate support for the operator.

This surface must:

a) Be rigid to prevent play between operator and

door shaft.

b) Provide a level base.

c) Permit the operator to be fastened securely and

with the drive shaft parallel to the door shaft.

The safety and wear of the operator will be adversely

affected if any of the above requirements are not met.

For metal buildings, fasten 2" x 2" x 3/16" (or larger)

angle iron frames to the building purlins. Retain

5-1/2" between frames. See Figure 1.

Both J and H series operators have dual output shafts and may be mounted on either the right (standard) or left

side of door, and in either a vertical (standard) or horizontal mounting position. If you need to move the drive

sprocket, loosen BOTH set screws, remove the sprocket and key, and place on the opposite side of the drive

shaft. Be sure to tighten BOTH set screws securely

Hand Chain Handing

For models H and HJ with manual hoist hand chain systems, the handing of the operator must be determined at

the time of order. The handing is indicated by last letter of the model name (R or L). The hand chain wheel can

not be switched on site. If your installation causes the hand chain to hang in the door opening, hook the chain

off to the side near the top of the door jamb.