How To Mount And Attach Options To The Lcd Monitor - NEC LCD5710-2-IT - MultiSync - 57" LCD Flat Panel Display User Manual

How to Mount and Attach Options to the LCD Monitor

You can attach mounting accessories to the LCD monitor in
one of the following two ways:
1. In the upright position
2. Lay the screen face down
Table
Lay the protective sheet which was wrapped around the
monitor when it was packaged on a table, beneath the
screen surface so as not to scratch the screen face.
This device cannot be used or installed without the Tabletop
Stand or other mounting accessory. Failure to follow correct
mounting procedures could result in damage to the
equipment or injury to the user or installer. Product warranty
does not cover damage caused by improper installation.
Failure to follow these recommendations could result in
voiding your warranty.
Please refer to "Mounting on Wall or Ceiling" section when
you mount your monitor on Wall or Ceiling. See page 35.
3. Ventilation Requirements for enclosure
mounting
To allow heat to disperse, leave space between surrounding
objects as shown in the diagram below.
4. To avoid falling down
Fasten the LCD monitor to wall using a cord or chain,
which is sufficient to support the weight of the LCD monitor
(approx. 66.0kg (145.5lbs)). The wall must be strong enough
to support the monitor and mounting accessories.
Protective Sheet
Cord or Chain
Tabletop Stand
Before moving the LCD monitor, the cord or chain should be
removed.
5. To prevent the main power switch from
being changed
To prevent use of the main power switch, please attach the
main switch cover, which is enclosed as an accessory.
NOTE: With the main power switch cover in place, the main
English-11
500mm
Screw Holes
Clamp
Screw
power switch cannot be turned off. Remove main
power switch cover in order to switch off the display.
Screw
Main switch cover