Remote Control Id Function - NEC LCD4020-BK-IT User Manual

REMOTE CONTROL ID
The remote control included with the display can be used
to control up to 26 individual MultiSync monitors us-
ing what is called the REMOTE CONTROL ID mode. The
REMOTE CONTROL ID mode works in conjunction with
the Monitor ID, allowing control of up to 26 individual
MultiSync monitors. For example: if there are many moni-
tors being used in the same area, a remote control in nor-
mal mode would send signals to every monitor at the same
time Figure 1. Using the remote in REMOTE CONTROL
ID mode will only operate one specific monitor within the
group Figure 2.
TO SET REMOTE CONTROL ID:
While holding down the REMOTE ID SET button on the
remote control, use the KEYPAD to input the Monitor
ID (1-26) of the display to be controlled via remote. The
remote can then be used to operate the monitor having that
specific Monitor ID number.
When 0 is selected or when the remote control is in normal
mode, all monitors will be operated.
TO USE REMOTE CONTROL ID MODE
ID Mode - To enter ID Mode press the REMOTE ID SET
button and hold down for 2 seconds.
Normal Mode - To return to Normal Mode press the
REMOTE ID RESET button and hold down for 2 seconds.
In order for this feature to work properly, the display must
be assigned a Monitor ID number. The Monitor ID number
can be assigned under the MULTI DISPLAY menu in the
OSD (See page 30).
You monitor ID in the center of display when your remote
control is ID mode.-
Part Names and Functions
Monitor ID:1
Remote works
Figure 1
Remote in Normal
mode or the REMOTE
ID is set to 0
Monitor ID:1
Remote does
not work
Figure 2
Remote set up to
use Remote ID:3
English-15
- continued

Remote Control ID Function

Monitor ID:2 Monitor ID:3
Remote works Remote works
Monitor ID:2 Monitor ID:3
Remote does Remote works
not work