Attaching Mounting Accessories - NEC LCD4020-BK-IT User Manual

Attaching Mounting Accessories

The display is designed for use with the VESA mounting
system.
1) Attach Mounting Accessories
Mounting accessories can be attached while the
monitor is on the Tabletop Stand in the upright
position (Figure 1). Be careful to avoid tipping
monitor when attaching accessories. After accessories
are attached, stand can be removed.
Mounting accessories can be attached with the
monitor in the face down position. To avoid damaging
the screen face, place the protective sheet on the
table underneath the LCD (Figure 2). The protective
sheet was wrapped around the LCD in the original
packaging. Make sure there is nothing on the table
that can damage the monitor.
When using mounting accessories other than NEC
compliant and approved, they must comply with the
VESA-compatible mounting method. NEC strongly
recommends using screws M6 size and 10mm in
length. If using screws longer than 10mm, check the
depth of the hole. (Recommended Fasten Force: 470-
635N•cm)
NEC recommends using mounting interface that
comply with UL1678 standard in North America.
VESA Mounting Interface
Figure 1
Figure 2
Table
English-7
Installation
- continued
Tabletop Stand
Protective Sheet
Tabletop Stand