Alliance Laundry Systems Stacked Drying Tumbler Operating And Maintenance Instruction Manual
  1. Manuals
  2. Brands
  3. Alliance Laundry Systems Manuals
  4. Dryer
  5. Stacked Drying Tumbler
  6. Operating and maintenance instruction manual
Alliance Laundry Systems Stacked Drying Tumbler Operating And Maintenance Instruction Manual

Alliance Laundry Systems Stacked Drying Tumbler Operating And Maintenance Instruction Manual

Stacked drying tumbler models with electronic control
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Stacked Drying
Tumbler
Models with Electronic Control
Keep These Instructions For Future Reference.
(If this tumbler changes ownership, be sure this manual accompanies the tumbler).
Part No. M412060R2
www.comlaundry.com
May 2006

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Stacked Drying Tumbler and is the answer not in the manual?

Questions and answers

Related Manuals for Alliance Laundry Systems Stacked Drying Tumbler

Summary of Contents for Alliance Laundry Systems Stacked Drying Tumbler

  • Page 1 Stacked Drying Tumbler Models with Electronic Control Keep These Instructions For Future Reference. (If this tumbler changes ownership, be sure this manual accompanies the tumbler). Part No. M412060R2 www.comlaundry.com May 2006...
  • Page 3 These instructions must be posted in a prominent location. Step-by-step instructions of the above information must be posted in a prominent location near the tumbler for customer use. M412060 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT MISE EN GARDE POUR VOTRE SÉCURITÉ, les informations de ce guide doivent être respectées afin de...

  • Page 4: Information For Handy Reference

    The model and serial numbers will be found on the serial plate located at the rear of the tumbler. Refer to page 7. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT WARNING WARNING Model No.

  • Page 5: Table Of Contents

    All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher. M412060 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Information For Handy Reference... Important Safety Instructions ...
  • Page 6 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Preventive Maintenance Instructions ... 33 Daily ... 33 Lint Removal ... 33 Monthly... 33 Lubrication ... 33 Lint Removal ... 33 Every Six Months ... 35 Lint Removal and Cylinder Belt Inspection ... 35 Drive System...

  • Page 7: Important Safety Instructions

    12. Keep area around the exhaust opening and adjacent surrounding area free from the accumulation of lint, dust and dirt. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060 (Save These Instructions) 13. The interior of the tumbler and the exhaust duct should be cleaned periodically by qualified service personnel.
  • Page 8 29. Run tumbler with a load before putting tumbler into service. WARNING To reduce the risk of serious injury, install lockable door(s) to prevent public access to rear of tumblers. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT W055 M412060...

  • Page 9: Introduction

    When writing for information on any tumbler, be sure to mention model and serial numbers. The model and serial numbers will be found on the nameplate as shown. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060 Introduction Replacement Parts Information...
  • Page 10 Notes © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060...

  • Page 11: Clearances

    (10.2 cm) 3-9/32 in 20-3/4 in (8.3 cm) (62.7 cm) 31-5/8 in (80.3 cm) © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060 28-1/4 in (71.8 cm) 28-1/4 in (71.8 cm) 33-3/4 in (85.7 cm) 42-5/8 in (108.3 cm) 43-1/2 in (110.5 cm)

  • Page 12: Specifications

    Boiler Horsepower Boiler Horsepower Inches W.C. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Electrostatically applied thermosetting polyester 30 in x 25 in (76.2 x 63.5 cm) perforated galvanized steel with three baffles 6 in (15.24 cm) 60 lbs.

  • Page 13: Installation Instructions

    The only thing common between the stacked drying tumbler and the standard drying tumbler is the floor © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060 space requirements. Twice the drying capacity means two separate heat sources, two separate cylinders/ drives, and two separate controls.

  • Page 14: Individual Venting

    1200 feet (366 m) per minute to ensure that the lint remains airborne. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Combined Exhaust Manifold Venting The upper and lower units may be exhausted into a combined exhaust manifold, refer to Figure 2.

  • Page 15: Individual Exhaust

    L Dia K Dia J Dia I Dia H Dia G Dia F Dia E Dia D Dia C Dia B Dia A Dia 2 in (5.1 cm) Minimum Clearance Wall No Screen Air Out or Cap © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060 HORIZONTAL EXHAUST INSTALLATION 180° Sweep Elbow 2 in (5.1 cm) Minimum Clearance 12 in (30.5 cm)

  • Page 16: Manifold Construction

    Installation Instructions Manifold Construction 17.50 in (44.5 cm) 3 in (7.6 cm) (3) Places 45° (2) Places © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 10 in (25.4 cm) Inside Diameter 2 in (5.1 cm) TYP Standard...

  • Page 17: Combined Exhaust Manifold

    First 4 in (10.2 cm) NOTE: Maximum length of exhaust duct is 14 feet (4.3 meters) beyond manifold duct. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060 HORIZONTAL EXHAUST INSTALLATION 180° Sweep Elbow 2 in (5.1 cm)

  • Page 18: Make-Up Air

    Tumbler must not rock. Shim under the corners to level and stabilize the unit. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Drying Tumbler Enclosure Construction IMPORTANT: DO NOT block the airflow at the top rear of the tumbler with laundry, etc.

  • Page 19: Leveling The Drying Tumbler

    IMPORTANT: An unleveled tumbler can cause rapid bearing wear, internal misalignment, scraping, noise, and possible clothes damage. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060 WARNING 12 in (30.5 cm)

  • Page 20: Gas Requirements (Gas Drying Tumblers)

    © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT information should be obtained from the gas supplier. Refer to table in Figure 7 for general pipe size. A dirt and water vapor pipe trap must be furnished and installed by customer.
  • Page 21 1/2 psig (3.45 kPa). © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060 Purge air and sediment from the gas service line before connecting it loosely to the tumbler.
  • Page 22 • with the latest edition of the “National Fuel Gas Code,” ANSI Z223.1/NFPA 54 in the U.S.A., • with CSA-B149.1 or Natural Gas and Propane Installaion Code in Canada, • and Australian Gas Association/Australian L.P. Gas Association requirements in Australia. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Equivalent Length 50 feet 75 feet (15.25 m)

  • Page 23: Example Of Gas Supply Piping

    (120,000 BTU/HR) Meter 25 ft (7.62 meters) © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060 IMPORTANT: Gas loop piping must be installed as illustrated to equalize gas pressure for all tumblers connected to single gas service.

  • Page 24: Electrical Requirements

    Never attempt to connect a live circuit. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Ground to Green Ground Screw Ground to Green Ground Screw Ground to Green Ground Screw...

  • Page 25: Grounding Instructions

    Refer to Figure 10. 3. Reinstall cover on the junction box. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060 Grounding Instructions This drying tumbler must be grounded. In the event of...
  • Page 26 1/2 psig (3.45 kPa). © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Purge air and sediment from the gas service line before connecting it loosely to the tumbler. Purge remaining air until odor of gas is detected, then tighten connection.

  • Page 27: Instructions For Lighting And Shutting Down Instant Electronic Ignition System

    4. If gas does not light, open and close loading door again and restart the ignition cycle. Position Position © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060 IMPORTANT: The Instant Electronic Ignition system will attempt to light the gas by sparking for approximately 15 seconds.
  • Page 28 Notes © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060...

  • Page 29: Adjustments

    INWARD towards machine (away from hinge) and repeat steps 1 and 2. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060 Adjustments 4. If the tab on the door operates the switch before...
  • Page 30 Adjustments © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Front Serial Plate Location Door Switch Figure 13 Figure 14 Door TMB2163N TMB2164N M412060...

  • Page 31: Operating Checks

    (45 to 57 mm). If it does not, adjust the loading door interlock. Refer to the appropriate paragraph in the Adjustments section of this manual. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060 Operating Checks 5. Start the tumbler and check the burner flame.
  • Page 32 Notes © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060...

  • Page 33: Operating Instructions

    NOTE: Electrical power to the tumbler must be on. The AVAILABLE light will be lit. Refer to Figure © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060 WARNING To reduce the risk of serious injury, allow cylinder to stop before cleaning lint screen.
  • Page 34 Notes © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060...

  • Page 35: Preventive Maintenance Instructions

    6. Reinstall the lint drawer, ensuring a tight fit and lock. IMPORTANT: Failure to lock lint drawer will result in the tumbler not starting. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060 WARNING Monthly Lubrication...
  • Page 36 Preventive Maintenance Instructions TMB2165N Figure 15 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060...

  • Page 37: Lint Removal And Cylinder Belt Inspection

    The belt should show no signs of excess wear or cracking. If it does, replace with a genuine service replacement. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M412060 Preventive Maintenance Instructions 4. Inspect the belt tensioning idler assembly. The...

  • Page 38: Three Month Maintenance

    Check for loose bolts. Check for loose screws. Check for loose gas connections. Check for loose electrical connections. Check for loose steam connections. (Steam Models Only.) © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT (DATES) (DATES) M412060...

Table of Contents

Save PDF