Table of Contents
Advertisement
Controls and their Functions (Continued)
2. Connector Section (Rear)
!4"
!5"
!1" AC Input Socket
!2" Fuse
!3" GND (ground) Terminal
!4" Dual-Link SDI Input
!5" Dual-Link SDI Output 1, 2
!6" HD-SDI Monitor Output
!7" Serial Data input (HD-SDI)
!8" Serial Data Output (HD-SDI)
!9" HD SYNC OUT
!10" HD REF IN
!11" HD Reference Through Output
(Auto Terminated)
!12" Service Switch
(only Use Service Maintenance)
!13" SERVICE ONLY (RS-232C)
<15pin>
(only Use Service Maintenance)
!6"
!7"
!8"
!9"
!13" !12" !10"
Use the accessory power cord to connect the socket to the power outlet
Power circuit fuse
When connected with another unit, the unit must be ground here
For inputting the Dual-Link digital signals
For outputting the Dual-Link or HD digital signals
(4:4:4/4:2:2 switchable)
For outputting the HD digital signals (4:2:2 samples)
This is connected to the HD SDI OUT connector on the HD-D5 VTR for
inputting for video/ audio/ tc output data from the HD-D5 VTR.
This is connected to the HD SDI IN connector on the HD-D5 VTR for
outputting the video/ audio/ tc data.
This is connected to the REF IN HD connector on the HD-D5 VTR.
The sync signal re-generated from the HD REF IN signal of the
processor.
For inputting the tri-level sync signals as reference signals
This is through output of input reference signal
This slide switch is used only in service mode.
Please Slide OFF for Normal Operation.
This connector is used only in service mode.
!11"
!2"
!1" !3"
7
Advertisement
Table of Contents
