Table of Contents
Advertisement
Note: Partitions that have a .VEF extension were loaded using
a drive on the duplicator. Partitions that were loaded directly to
the duplicator's hard drive from a PC have a .ISO extension.
Step 6:
Choose the desired partition to copy from using the up or down
button and press the >> button to submit your selection. You should then
see the Counter Selection menu.
The Counter Selection menu will let you to choose how many copies you
want to make for your project. This counter selection feature will allow the
duplicator to count the number of copies you have made and prompt you
when the desired number of copies has been made.
You can select "No Counter" if you prefer to copy continuously with no in-
terruption. (It will still count the number of copies, but it will not notify you
when to stop.) To select the No Counter, simply press the >> button when
you see the above screen. Then skip below and continue to Step 8.
Or, you can select specify counter to between 1 to 9999 by pressing the up
or down navigation button to the following screen.
Then press >> button to submit. You should see the following screen.
To specify the number of copies for your project, you need to enter or input
a 4-digit number. If you are planning to specify a number that is less than
4 digits, fill the leading spaces with 0s (any leading zero will be skipped).
An example of that 4-digit number could be 0234 (two hundred thirty
four), or 0010 (ten). Remember, the beginning 0s are skipped, therefore,
0010 means 10, which is the number ten.
Xerox Duplicator
Choose Partition:
[FUN.VEF] 714MB
Counter:
No Counter
Counter:
Specify Counter
Specify Counter:
[
0
]
OK?
30
Advertisement
Table of Contents
