Brother CP-1800 User Manual page 15

4
Set the power supply switch on the left side of the printer to "|" to turn on
the copyboard.
1
Feeding the copyboard
The copyboard has two writing surface areas. When you wish to use the other writing
surface area, press f to scroll the writing surface without printing.
b
Do not try to erase or touch the writing surface while it is moving.
Do not touch the paper being fed out of the printer until it has finished feeding.
Writing & printing
1
Make sure that the power supply switch on the left side of the printer is
set to "|".
2
Write within the scannable area shown in the illustration below.
b
Only use the enclosed Dry Erase markers or markers of the same type. The
use of non-erasable markers will void the warranty.
Do not allow the seam of the writing surface to become dirty.
3
0.44 in.
(11 mm)
3. Operation
4
2
0.44 in.
(11 mm)
0.12 in.
(3 mm)
0.12 in.
(3 mm)
13