Brother CP-1800 User Manual page 10

2. Setup
Partition mounting
Follow the precautions below to mount the copyboard correctly on the partition
and reduce the risk of it falling down.
a
Before attempting to hang your copyboard on a cubicle wall or partition, consult
the manufacturer of the partition to verify that the partition is capable of support-
ing the copyboard without adverse consequences.
The enclosed partition-mounting brackets allow you to hang the copyboard on a
standing partition 1.5 in. to 4 in. (38 mm to 102 mm) thick and sturdy enough to
withstand a weight of at least 77.3 lbs. (35 kg).
Do not install, adjust, or remove the partition-mounting brackets with the copyboard
hanging from the wall-mounting bar. Always remove the copyboard beforehand.
1
Attach the two fixed parts of the partition-mounting brackets to the wall-
mounting bar with the four enclosed screws.
2
Insert the ends of the movable parts of the
partition-mounting brackets into the fixed parts.
+
3
While holding the partition-mounting brackets
clamped around the top of the partition, tighten
the knobs.
8
Either end of the movable part of the bracket
can be used depending on the width of the
partition. Insert the end stamped A if the
partition is 1.5 in. to 2.8 in. (38 mm to 71 mm).
Insert the end stamped B if the partition is 2.7
in. to 4 in. (69 mm to 102 mm).