Updating The Server Configuration - IBM x3500 - System - 7977 Installation Manual

4. Repeat step 2 for the remaining hinge.

Updating the server configuration

When you start the server for the first time after you add or remove an internal or
external device, you might receive a message that the configuration has changed.
The Configuration/Setup Utility program starts automatically so that you can save
the new configuration settings. For more information, see the section about
configuring the server in the User's Guide on the IBM System x Documentation CD.
Some optional devices have device drivers that you must install. See the
documentation that comes with each device for information about installing device
drivers.
The server comes with at least one microprocessor. If more than one
microprocessor is installed, the server can operate as a symmetric multiprocessing
(SMP) server. You might have to upgrade the operating system to support SMP. For
more information, see the section about using the ServerGuide Setup and
Installation CD in the User's Guide and the operating-system documentation.
If the server has an optional RAID adapter and you have installed or removed a
hard disk drive, see the documentation that comes with the RAID adapter for
information about reconfiguring the disk arrays.
If you have installed a Remote Supervisor Adapter II SlimLine to manage the server
remotely, see the Remote Supervisor Adapter II SlimLine User's Guide, which
comes with the adapter, for information about setting up, configuring, and using the
adapter.
For information about configuring the integrated Gigabit Ethernet controller, see the
User's Guide.
33
Chapter 2. Installing optional devices