Table of Contents
Advertisement
1 Service Access Cover
2 Model 275
3 Slimline Diskette (Media Bay 2)
SCSI Media Devices
The SCSI media device bay is a full-height bay for SCSI devices only.
SCSI Media Device Removal
To remove a SCSI media device, do the following:
1. Open the bezel door.
2. Remove the media bay chassis as described in "Media Bay Chassis" on page 44.
3. Unplug the SCSI cable and power cable from the rear of the SCSI media device and the backplane at
the rear of the media bay chassis.
4. Detach the media drive from the media bay chassis.
5. Put the media drive in a safe place.
SCSI Media Device Installation or Replacement
To replace a media device, do the following:
1. Before handling any card, board, or memory DIMM, be sure to use your electrostatic discharge strap to
minimize static-electric discharge. Refer to "Handling Static-Sensitive Devices" on page 24.
2. Attach the media drive to the media bay chassis.
3. Plug the SCSI cable and the power cable into the rear of the SCSI media device and the backplane at
the rear of the media bay chassis.
4. Replace the media bay chassis as described in "Media Bay Chassis" on page 44.
5. Replace the bezel as described in "Front Bezel Replacement" on page 27.
Replacing SCSI Media Device Power Cables and SCSI Cables
To replace SCSI media device power cables or SCSI cables, see "SCSI Media Device Removal" and
"SCSI Media Device Installation or Replacement".
4 Slimline CD-ROM (Media Bay 1)
5 SCSI Media Device (for example: Tape
Drive, DVD-RAM Drive)
Chapter 3. Installing Options
43
Advertisement
Table of Contents
