Table of Contents
Advertisement
WG103 ProSafe 802.11g Wireless Access Point Reference Manual
You Cannot Configure the Wireless Access Point from a
Browser
Check the following:
•
The wireless access point is properly installed, LAN connections are OK, and it is powered on.
Check that the LAN port LED is on (amber indicating a 10 Mbps Ethernet connection or green
indicating a 100 Mbps Ethernet connection) to verify that the Ethernet connection is OK.
•
If you are using the NetBIOS name of the wireless access point to connect, ensure that your
computer and the wireless access point are on the same network segment or that there is a
WINS server on your network.
•
If your computer uses a fixed (static) IP address, ensure that it is using an IP address in the
range of the wireless access point. The wireless access point default IP address is
192.168.0.229 and the default subnet mask is 255.255.255.0. The wireless access point default
setting is for a static IP address. If the network where you are connecting it is using DHCP,
configure it accordingly (see
•
Make sure that your browser has Java, JavaScript, or ActiveX enabled. If you are using
Internet Explorer, click Refresh to be sure that the Java applet is loaded.
•
Try quitting the browser and launching it again.
•
Make sure that you are using the correct login information. The factory default login name is
admin, and the password is password. Make sure that Caps Lock is off when entering this
information.
If the wireless access point does not save changes you have made in the Web configuration
interface, check the following:
•
When entering configuration settings, be sure to click the Apply button before moving to
another screen or tab, or your changes are lost.
•
Click the Refresh or Reload button in the Web browser. The changes might have occurred, but
the Web browser might be caching the old configuration.
6-4
"Configure Basic IP Settings" on page
v1.0, February 2009
2-7).
Troubleshooting
Hide quick links:
Advertisement
Table of Contents
