NETGEAR WG103 - ProSafe - Wireless Access Point Reference Manual page 69

Figure 4-14
3. Select the Enable radio button to enable SNMP remote management.
4. Enter the following information according to the requirements of your location:
• Read-Only Community Name. The community string to allow the SNMP manager to
read the MIB objects of the wireless access point. The default setting is public.
• Read-Write Community Name. The community string to allow the SNMP manager to
read and write the MIB objects of the wireless access point. The default setting is private.
• Trap Community Name. The community name that is associated with the IP address to
receive traps.
• IP Address to Receive Traps. Enter the IP address of the device that should receive the
traps that are sent from the wireless access point. If you do not want traps to be sent, leave
this field blank.
• Trap Port. The port number where traps will be sent. The default port is 514.
• SNMP Manager IP address. Enter the IP address of the SNMP manager. If this address
is set to 255.255.255.255, any SNMP manager will be allowed.
5. Click Apply to save your changes.
Managing Your Network
WG103 ProSafe 802.11g Wireless Access Point Reference Manual
v1.0, February 2009
4-17