How To Configure Repeater Mode - NETGEAR WG103 - ProSafe - Wireless Access Point Reference Manual

• Wireless stations will not be able to connect to any wireless access points in this
configuration (see
LAN segment, you can use additional wireless access points configured in regular access
point mode to any LAN segment.
Note: You can extend this multi-point bridging configuration by adding additional
wireless access points that are configured in point-to-point mode for each
additional LAN segment. Furthermore, you can extend the range of the wireless
network with NETGEAR wireless antenna accessories.

How to Configure Repeater Mode

Select this option to enable the wireless access point to operate as a repeater only without
communication with other wireless clients. All traffic is sent to the remote or "downstream"
wireless access point. Up to four profiles can be configured.
The following figure shows an example of a repeater mode configuration.
Figure 5-9
Advanced Configuration
WG103 ProSafe 802.11g Wireless Access Point Reference Manual
Figure 5-8 on page 5-11). If you require wireless stations to access any
v1.0, February 2009
5-13