Advanced; Static Route - 3Com 3CRWE554G72T - OfficeConnect Wireless 11g Cable/DSL Router User Manual

Advanced

Static Route

The upgrade procedure can take up to two minutes, and is complete
when the Alert LED has stopped flashing and is permanently off. Make
sure that you do not interrupt power to the Router during the upgrade
procedure; if you do, the software may be corrupted and the Router may
not start up properly afterwards. If the Alert LED comes on continuously
after a failed upgrade, refer to
Selecting Advanced from the main menu displays the following five tabs
in your Web browser window: Static Route, RIP, Routing Table, DDNS
and Security.
The Router supports static route functionality. Select the Static Route tab
to display the screen shown in
Figure 70 Static Route screen
The following information is displayed for each static route:
Index - the index of the static route
■
Network Address - the network address of the route. If network
■
address and subnet mask are both set to 0.0.0.0, this is the default
route.
Subnet Mask - the subnet mask of the route. If network address and
■
subnet mask are both set to 0.0.0.0, this is the default route.
Chapter 6, "Troubleshooting".
Figure 70
Advanced 91